Product overview

Flame-Retardant Sealing & Vent Components

Die-cut seals, gaskets and vent-adjacent parts for normal environmental duty and defined event behavior.

Project feasibility reviewSupply and converting feasibility for this construction are confirmed individually after reviewing your drawing and material specification.

Representative custom die-cut vent and sealing components
Representative component photograph. Final construction is confirmed for your drawing.

Application requirements

Where this component is used

Leakage, water ingress, compression, opening pressure and event flow are separate requirements that must not be hidden behind one material label.

We convert candidate elastomer, foam, film, mesh or membrane components and control the geometry, adhesive and liner to drawing.

Position and function

Installation positions and primary functions

Installation positions

  • Pack seam
  • Pressure vent
  • Lid outlet
  • ESS cabinet
  • Cable and service interface

Primary functions

  • Normal-service sealing
  • Pressure equalization
  • Vent-adjacent protection
  • Assembly compression control

Selection criteria

Key inputs for component selection

Decision dimensionWhat must be defined
MediaDefine air/gas, water, condensate and fluid exposure.
PressureState normal differential, opening and event conditions.
CompressionCalculate installed strain around flange tolerance.
LifeDefine cycles, aging and post-condition leak/flow criteria.

Engineering data

Available parameters and validation status

Verified test resultTypical material valueAvailable rangeCustomizable targetApplication validation required
ParameterValue / rangeConditionMethodEvidence state
MaterialElastomer, foam, film, mesh or membrane candidateDefine with applicationGrade / project specificApplication validation required
Compression / sealingGeometry and grade specificDefine with applicationGrade / project specificApplication validation required
Environmental evidenceComplete enclosure validation requiredDefine with applicationGrade / project specificApplication validation required
Adhesive / linerCustom to assembly processDefine with applicationGrade / project specificCustomizable target

These ranges support initial selection. Final values are confirmed for the approved grade, converted construction, thickness, conditioning and test method.

Data required

Inputs for an engineering review

  • Port/flange drawing
  • Normal leak or IP target
  • Flow and pressure curve
  • Temperature and media
  • Compression, adhesive and cycle life

Continue the evaluation

Related products and applications

Frequently asked questions

Clear answers before sampling

Can a seal carry a universal IP rating?

No. IP applies to the complete enclosure and installation under the named test.

Can flame-retardant mean fireproof?

No. Any classification applies to a specific material thickness and test method, not unlimited fire exposure.

Can the liner include pull tabs?

Yes, subject to geometry and process feasibility; tabs can improve assembly repeatability.

SAMPLES & ORDERING

Samples and order quantities

No MOQ in principleSample, pilot and production quantities welcome
Samples within 7 daysAfter drawing, material and sample requirements are confirmed
Sample fee by batchCost and freight confirmed before you proceed
Delivery, payment and shipping questions

Custom engineering review

Submit Environmental Requirements

Submit your application